BABYMAKER 1000 KIT - 07.5-18 68RFE

The valve body is flat sanded to our tolerances. We install HD billet accumulators proven to prevent bore wear and
provides unsurpassed sealing qualities. Sonnax accumulator plate cover with 3 additional bolts
eliminating plate blowout. SSV is reamed out and Transgo switch valves are installed to correct wear and leaks. All valve body bores are vacuum tested to insure hydraulic integrity. HD billet channel plate is installed onto
the valve body and torqued to our specifications preventing cross leaks which results in premature transmission failure.
Includes new O.E solenoid block.

Built and tested in house 

THIS WILL NOT FIX A TRANSMISSION WITH RATIO CODES. IF YOU'RE EXPERIENCING THIS ISSUE, THE TRANSMISSION IS HURT. 

Will Fit With OE Transmission Pan

Comes With:

Valve Body, Mag Hytec or Equivalent Deep Pan, Gasket, Filters, And Billet Filter Adaptor.

For 2007.5 - 2018 68RFE Transmissions Only.

To unlock the full potential of the Babymaker, it requires trans tuning. 

If you do not have tuning, this will, at minimum eliminate cross leaks.

THIS IS THE INFORMATION YOUR TUNER WILL NEED TO PROPERLY TUNE FOR THE BABYMAKER:

• LINE PRESSURE SET TO 225PSI ABOVE 30% THROTTLE ANGLE

• 100PSI RESTING PRESSURE

• NO LOCKUP UNTIL 4TH GEAR

• LOW/REVERSE SPRAG HOLDOUT

• FOR 2019+, UNDERDRIVE PULSE TEST MUST BE TURNED OFF.