- DIY Kits
- Contact Us
© 2020 Randy's Transmissions. All Rights Reserved.
The Industrial Injection 100hp / 20% Over Race 1 Injectors have been extrude honed and balanced to a perfect matching set injectors that flow 30LPM. The Race 1 100HP / 20% Over injectors can be run with a stock turbo but one of our Phatshaft turbos or our compound turbo setups is highly recommended to help reduce EGTs. We typically see a 1-3MPG increase in fuel economy. We balance the injectors to a tighter tolerance than the original manufacturer and have put a lot of time into making these the best injectors money can buy. All the injectors we build in house are built with BRAND NEW Factory OEM parts including the nozzles.
These injectors come with a new copper crush washer and o-rings for installation. Injectors are an OEM Genuine part that is a direct replacement injector. Each injector is individually tested on a state of the art Factory OEM test stand to ensure that they meet or exceed OEM specifications. Each test includes a resistance test, system leak test, purge, idle speed test, mid load test, full load test, and static back leak test. Each test cycle checks solenoid response time, back leak flow, and fuel delivery.
When replacing the injectors in your 6.7L Common Rail we highly recommend replacing the injector connecting tubes to avoid new injector contamination. The most common failure of new injector installations is contamination and the problem that we see most on these comes from the injector connecting tubes.
Each injector has a $150 core charge and is fully refundable if they are shipped back within 45 days.
All Industrial Injection products are covered by a one year/unlimited mile warranty.
NOTE: Please call with Engine Serial Number to verify application!
*All Industrial Injection Performance Products Are Not Legal For "On-Road", "Off-Road", or "Dual-Use". These Products May Only Be used In "Closed Circuit Competition Only" Vehicles. Compliance With State And Federal Emission Standards Is The Consumer's Responsibility.